NOOR has a quite professional testing and commission policy drive the project to safe and operable condition.

NOOR has expert engineers and measurement tools to provide several testing and commissioning services like but not limited to;

HVAC Equipment & System

  • Variable Speed Drives
  • Hydronic Pipung System
  • HVAC Pumps
  • Boilers
  • Chemical Treatment System
  • Air Cooled Condensing Units
  • Makeup Air Systems
  • Air Handling Units
  • Underfloor Air Distribution
  • Centrifugal Fans
  • Ductwork
  • Fire / Smoke Dampers
  • Automatic Temperature Control-Inclding an Intentional sequence of operation
  • Laboratory Fume Hoods
  • Testing, Adjusting. And Balancing
  • Building / Space Pressurization
  • Ceiling Radiant Heating
  • Underfloor Radiant Heating

Building Envelope

  • Building Insulation Installation
  • Building Roof Installation Methods
  • Doors & Windows Installation Methods
  • Water Infiltration / Shall Drainage Plain

Plumbing System

  • Domestic Watefr Heaters
  • Air Compressor & Dryer
  • Storm Water Oil / Grit Seperators

Electrical Equipment & System

  • Power Distribution System
  • Lighting Control System
  • Lighting Control Programs
  • Engine Generators
  • Transfer Switches
  • Switchboard
  • Panelboards
  • Grounding
  • Fire Alarm & Interface Item With HVAC
  • Security System

“Commisioning needs may differ by project; however, commisioning the building envelope systems, domestic water heating, power distribution, ductwork, and any hydronic piping systems is strongly recommended for any project.”

Testing and Commissioning Policy


Pre-Commissioning activities start when the system, achieves Completion. Frequently however, Pre-Commissioning activities overlap Completion activities and for this reason the system should be separated into easily manageable system package, each system package will be maintained until the completion of Pre-Commissioning activities. Pre-Commissioning activities include: checking for design conformity, checking the status of electrical, mechanical and instrument installation, running – in of equipment, flushing and cleaning activities, drying, etc.


Commissioning is the phase in a project when design requirements are introduced to the process. Note that for MEP system the commissioning activities commence with interting operations. Commissioning activities normally consist of activities associated with running or operating the facility and include operation adjustment necessary for satisfactory operation of the facility or part thereof. Also included are “Functional checks” which are methods used to prove that an item of equipment or control system functions correctly.

Start-up is the point in a project where process and conditions are established with the intent of making products.

A section of the facility that can be Pre-Commissioned and commissioned independently but in parallel, with other sections of the facility under construction.

This is the point in a where all utilities are commissioned and operational and the unit is ready to accept production.

This is the Point in a project where the unit is ready to establish process conditions with the intent of making product.

Our Certificates

  • ISO 9001:2015 Quality management system
  • ISO14001:2015 Environmental management system and OHSAS18001:2007 For occupational health and safety management system.
  • Factory control production certificates according to BS 5950 and AWS D.1.1
  • AISC Certificate for steel structure fabrication
  • AGA
  • Dun & Bradstreet Number